ASTM-E690 › Standard Practice for In Situ Electromagnetic (Eddy Current) Examination of Nonmagnetic Heat Exchanger Tubes
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes procedures to be followed during eddy-current examination (using an internal, probe-type, coil assembly) of nonmagnetic tubing that has been installed in a heat exchanger. The procedure recognizes both the unique problems of implementing an eddy-current examination of installed tubing, and the indigenous forms of tube-wall deterioration which may occur during this type of service. The document primarily addresses scheduled maintenance inspection of heat exchangers, but can also be used by manufacturers of heat exchangers, either to examine the condition of the tubes after installation, or to establish baseline data for evaluating subsequent performance of the product after exposure to various environmental conditions. The ultimate purpose is the detection and evaluation of particular types of tube integrity degradation which could result in in-service tube failures.
1.2 This practice does not establish acceptance criteria; they must be specified by the using parties.
1.3 This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Condenser and heat exchanger systems; Electromagnetic (eddy current) testing; Nonmagnetic heat exchanger tubes; in-situ electromagnetic (eddy-current) examination of nonmagnetic heat; exchanger tubes, practice; ICS Number Code 27.060.30 (Boilers and heat exchangers)
To find similar documents by ASTM Volume:
03.03 (Nondestructive Testing)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
NAS-410NAS Certification and Qualification of Nondestructive Test Personnel
MIL-H-7199
Heat Treatment of Wrought Copper-Beryllium Alloys, Process for (Copper Alloys: Numbers C17000, C17200, C17300, C17500, and C17510) (Superseded by SAE-AMS-H-7199)
DODISS-CD-ROM-SUBSCR
Department of Defense Index of Specifications and Standards - No Longer Available
Document Number
ASTM-E0690-15R20
Revision Level
2015 R20 EDITION
Status
Current
Modification Type
Revision
Publication Date
July 14, 2020
Document Type
Practice
Page Count
5 pages
Committee Number
E07.07