ASTM-E775 › Standard Test Methods for Total Sulfur in the Analysis Sample of Refuse-Derived Fuel
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
Changes from the previous issue
A redline edition is available for this document, with all changes visible. Ask Document Center Inc. for more information.
1.1 These test methods present two alternative procedures for the determination of total sulfur in prepared analysis samples of solid refuse-derived fuel (RDF). Sulfur is included in the ultimate analysis of RDF.
1.2 The test methods appear in the following order:
Bomb Washing Method
1.3 These test methods may be applicable to any waste material from which a laboratory analysis sample can be prepared.
1.4 The values stated in SI units are to be regarded as standard. Inch-pound units are provided for information.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements see Section .
ICS Number Code 75.160.10 (Solid fuels)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Sept. 15, 2015