ASTM-E815 › Historical Revision Information
Standard Test Method for Determination of Calcium Fluoride in Fluorspar by Complexometric Titrimetry
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of calcium fluoride in acid-grade fluorspar and other types of fluorspar that can be rendered soluble by the procedure described in the test method.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This test method has been evaluated in accordance with Practice E1601 and Guide E1763. Unless otherwise noted in the precision and bias section, the lower limit in the scope of each method specifies the lowest analyte content that may be analyzed with acceptable error (defined as a nominal 5 % risk of obtaining a 50 % or larger relative difference in results on the same test sample in two laboratories).
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
Fluorspar is used as a flux in steelmaking, glass industry, and manufacture of hydrofluoric acid.
This test method is intended to be used for compliance with compositional specifications for calcium fluoride content. It is assumed that all who use these procedures will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory and that proper waste disposal procedures will be followed. Appropriate quality control practices must be followed such as those described in Guide E882.
Keywords
calcium content; calcium fluoride content; complexometric titrimetry; fluorspar; soluble calcium content: Calcium content; Calcium fluoride (CaF
To find similar documents by ASTM Volume:
03.05 (Analytical Chemistry for Metals, Ores, and Related Materials: E 32 - latest)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E815-11
Revision Level
2011 EDITION
Status
Superseded
Modification Type
Revision with Title Change
Publication Date
Oct. 1, 2011
Document Type
Test Method
Page Count
4 pages
Committee Number
E01.02