ASTM-E828 Standard Test Method for Designating the Size of RDF-3 From its Sieve Analysis (Withdrawn 2009)

ASTM-E828 - 1981 R04(E1) EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Designating the Size of RDF-3 From its Sieve Analysis (Withdrawn 2009)

Scope

1.1 This test method of designating the size of refuse-derived fuel from its sieve analysis is applicable to the classified light fraction (RDF-3) of shredded municipal or industrial waste materials less than 0.15 m (6 in.) in size.

1.2 The values stated in acceptable metric units are to be regarded as standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For more specific precautionary information see Section 7.

Significance and Use

The purpose of this test method is to provide a means of designating the size classification of RDF-3 for use by consumers and producers of RDF-3.

Keywords

ICS Number Code 19.120 (Particle size analysis. Sieving)

To find similar documents by ASTM Volume:

11.04 (Waste Management)

To find similar documents by classification:

19.120 (Particle size analysis. Sieving Including test sieves and porosimetry)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-E828-81(2004)e1

Revision Level

1981 R04(E1) EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

May 1, 2006

Document Type

Test Method

Page Count

8 pages

Committee Number

D34.03