ASTM-F1039 › Standard Test Method for Measurement of Low Level X-Radiation Used in X-Ray Security Screening Systems (Withdrawn 2002)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method establishes the procedures for measuring the ionizing radiation inside the radiation chamber of a low level X-ray security screening system.
1.2 This test method establishes minimum requirements for the radiation detector used to measure this ionizing radiation inside the radiation chamber.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this test standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in Section 7.
Keywords
Airport security; High security areas; Ionizing radiation; Public access buildings; Radiation exposure-security applications; Screening systems; Security systems and equipment; Terminals; X-irradiation; low-level x-radiation (used in x-ray security screening systems), test,; Low-level x-radiation sensitivity; used in x-ray security screening systems, test; ICS Number Code 17.240 (Radiation measurements); 19.100 (Non-destructive testing)
To find similar documents by ASTM Volume:
To find similar documents by classification:
17.240 (Radiation measurements Including dosimetry Radiation protection, see 13.280)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1039-87(1993)e1
Revision Level
1987 R93(E1) EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
April 1, 1993
Document Type
Test Method
Page Count
3 pages
Committee Number
F12.60