ASTM-F1048 Standard Test Method for Measuring the Effective Surface Roughness of Optical Components by Total Integrated Scattering (Withdrawn 2003)

ASTM-F1048 - 1987 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Measuring the Effective Surface Roughness of Optical Components by Total Integrated Scattering (Withdrawn 2003)

Scope

This standard was transferred to SEMI (www.semi.org) May 2003

1.1 This test method covers the measurement of the effective surface roughness of an opaque reflecting surface as determined by the total integrated light scattering (TIS).

1.2 Applications:

1.2.1 This test method is particularly applicable to metal mirrors or smooth dielectrics covered with an opaque reflecting surface.

1.2.2 This test method is applicable to specimens ranging in size from 5 mm in diameter to as large as the supporting components will accommodate. The sampling area is approximately 1 mm in diameter.

1.3 Limitations -This test method is limited to specimens with optical surfaces that are flat or that are spherical with a radius of curvature greater than 10 m.

1.4 This test method determines the integrated scattering from an angle approximately 2.5° from the surface normal to an angle approximately 70° from the surface normal.

1.5 The test method is performed with a helium-neon laser operating at the wavelength 632.8 nm.

1.6 Repeated use of this test method on different areas of the specimen permits mapping of the surface TIS.

1.7 This test method is nondestructive.

1.8 The maintenance of a control chart to monitor the stability of the measurement process is discussed in Annex A1.

1.9 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Section 8.

Keywords

Dielectrics; Diffuse reflectance; Effective surface roughness; Flat optical surfaces; Helium-neon laser; Integrated light scattering; Lasers and laser applications; Light-scattering; Metal mirrors; Microroughness; Mirrors; Monitoring-semiconductor processing; Nondestructive evaluation (NDE)-semiconductors; Radiation exposure-electronic components/devices; Reflectance and reflectivity-electronic materials/applications; Roughness; Scattering parameters; Solar collectors; Solar spectral irradiance; Spherical optical surfaces; Surface analysis-electronic components/devices; optical components-effective surface roughness, by total integrated; scattering, test; ICS Number Code 37.020 (Optical equipment)

To find similar documents by ASTM Volume:

10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)

To find similar documents by classification:

37.020 (Optical equipment Including microscopes, telescopes, binoculars, optical materials, optical components and optical systems Ophthalmic equipment, see 11.040.70 Optical measuring instruments, see 17.180.30 Photographic equipment lenses, see 37.040.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in Paper format.

Document Number

ASTM-F1048-87

Revision Level

1987 EDITION

Status

Superseded

Modification Type

Withdrawn

Publication Date

May 29, 1987

Document Type

Test Method

Page Count

6 pages

Committee Number

F01.06