ASTM-F106 › Standard Specification for Brazing Filler Metals for Electron Devices (Withdrawn 2024)

ASTM-F106 - 2012 R17 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This specification covers brazing filler metals for use in electron devices in a nonoxidizing atmosphere. Material covered by this specification consists of vacuum grade (Grades 1 and 2) brazing filler metals manufactured in the form of strip, wire, or preforms made by blanking the trip or bending the wire. Brazing filler metals in the form of powder are also available. Filler metals in wire form shall be in soft temper condition, most suitable for hand feeding or ring winding in mandrels, while those in strip form shall be in hard as-rolled temper condition to facilitate clean blanking of thin shims or preforms. The surface of the filler metal, whether strip, wire, or preform, shall be as smooth and free of dirt, oxide, pits, deep scratches, seams, slivers, stains, scale, blisters, edge cracks, trimming burrs, waves, wrinkles, and other defects as commercially possible. Melting test for cleanness and spatter shall be performed and shall conform to the requirements specified.

ORDER

Want this as a site license?

Scope

1.1 This specification covers requirements or filler metals suitable for brazing internal parts and other critical areas of electron devices in a nonoxidizing atmosphere (Note 1).

1.2 These materials are available in strip or wire or preforms made by blanking the strip or bending the wire. Powders are also available.

Note 1: Brazing filler metals for general applications are specified in AWS Specification A 5.8.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

braze alloys; electron devices; melting test for cleanness and spatter;

To find similar documents by ASTM Volume:

02.04 (Nonferrous Metals--Nickel, Cobalt, Lead, Tin, Zinc, Cadmium, Precious, Reactive, Refractory Metals and Alloys; Materials for Thermostats, Electrical Heating and Resistance Contacts, and Connectors)

10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)

To find similar documents by classification:

25.160.50 (Brazing and soldering Including brazing and soldering alloys and equipment)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

ASQ-Z1.4
Sampling Procedures and Tables for Inspection by Attributes - Paper Format - Reaffirmed in 2018

MIL-STD-810
Environmental Engineering Considerations and Laboratory Tests

ASTM-E384
Standard Test Method for Microindentation Hardness of Materials

Document Number

ASTM-F106-12(2017)

Revision Level

2012 R17 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

June 1, 2017

Document Type

Specification

Page Count

6 pages

Committee Number

B02.05