ASTM-F1093 Standard Test Methods for Tensile Strength Characteristics of Oil Spill Response Boom

ASTM-F1093 - 1999 R18 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Methods for Tensile Strength Characteristics of Oil Spill Response Boom
ORDER

Price:

$46.00        


Want this as a site license?

Scope

1.1 These test methods cover static laboratory tests of the strength of oil spill response boom under tensile loading.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 7.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Significance and Use

5.1 Boom sections are frequently combined into assemblages hundreds of meters in length prior to towing through the water to a spill site. The friction of moving long boom assemblages through the water can impose high tensile stresses on boom segments near the tow vessel.

5.2 Tensile forces are also set up in a boom when it is being towed in a sweeping mode. The magnitude of this tensile force can be related to the immersed depth of the boom, the length of boom involved, the width of the bight formed by the two towing vessels, and the speed of movement.

Note 1: When the towing speed exceeds about 1 knot (0.5 m/s), substantial oil will be lost under the boom.

5.3 Knowledge of maximum and allowable working tensile stresses will help in the selection of boom for a given application and will permit specification of safe towing and anchoring conditions for any given boom.

To find similar documents by ASTM Volume:

11.05 (Pesticides and Alternative Control Agents; Environmental Assessment; Hazardous Substances and Oil Spill Response)

To find similar documents by classification:

13.060.99 (Other standards related to water quality)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

MIL-HDBK-695
Rubber Products: Recommended Shelf Life

ASTM-D2240
Standard Test Method for Rubber Property—Durometer Hardness

49CFR(178-199)
Transportation

Document Number

ASTM-F1093-99(2018)

Revision Level

1999 R18 EDITION

Status

Current

Modification Type

Reapproval

Publication Date

April 1, 2018

Document Type

Test Method

Page Count

4 pages

Committee Number

F20.11