ASTM-F1145 › Historical Revision Information
Turnbuckles, Swaged, Welded, Forged, Standard Specificationfor
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers swaged welded, cast, or forged turnbuckles with and without jam nuts.
1.2 A turnbuckle is an internally threaded loop or sleeve intended for assembly with a threaded stud, eye, hook, or jaw at each end, used for applying tension to rods, wire rope, etc.
1.3 The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information purposes only and may be approximate.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
forged turnbuckles; open turnbuckle body; pipe turnbuckle body; rigging turnbuckle body; swaged turnbuckle; turnbuckle; welded turnbuckle; ICS Number Code 21.060.70 (Clamps and staples)
To find similar documents by ASTM Volume:
01.07 (Ships and Marine Technology)
To find similar documents by classification:
21.060.70 (Clamps and staples)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1145-88
Revision Level
1988 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
April 29, 1988
Document Type
Specification
Page Count
10 pages
Committee Number
F25.07