ASTM-F1145 Historical Revision Information
Standard Specification for Turnbuckles, Swaged, Welded, Forged

ASTM-F1145 - 1992 R97 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Specification for Turnbuckles, Swaged, Welded, Forged
ORDER

Scope

1.1 This specification covers swaged welded, cast, or forged turnbuckles with and without jam nuts.

1.2 A turnbuckle is an internally threaded loop or sleeve intended for assembly with a threaded stud, eye, hook, or jaw at each end, used for applying tension to rods, wire rope, etc.

1.3 The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information purposes only and may be approximate.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

forged turnbuckles; open turnbuckle body; pipe turnbuckle body; rigging turnbuckle body; swaged turnbuckle; turnbuckle; welded turnbuckle; ICS Number Code 21.060.70 (Clamps and staples)

To find similar documents by ASTM Volume:

01.07 (Ships and Marine Technology)

To find similar documents by classification:

21.060.70 (Clamps and staples)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-F1145-92(1997)

Revision Level

1992 R97 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

Aug. 15, 1992

Document Type

Specification

Page Count

10 pages

Committee Number

F25.07