ASTM-F1159 › Standard Practice for Design of Amusement Rides and Devices that are Outside the Purview of Other F24 Design Standards
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
Changes from the previous issue
A redline edition is available for this document, with all changes visible. Ask Document Center Inc. for more information.
1.1 This practice establishes information and procedures for the design of amusement rides and devices and major modifications to amusement rides and devices which the designer/engineer identifies as outside the purview of other ASTM F24 design standards.
1.1.1 Prior to designating an amusement ride or device as outside the purview of other ASTM F24 standards and subject to Practice , the designer/engineer shall perform a review of all standards under the jurisdiction of the ASTM Committee F24 addressing amusement ride and device design and determine that Practice is appropriate and more applicable to the amusement ride or device than other ASTM Committee F24 practices addressing amusement ride and device design.
1.1.2 In making such a determination, the designer/engineer shall consider the following:
184.108.40.206 The general nature of the amusement ride or device;
220.127.116.11 The absence of relevant specific requirements or features addressed by other ASTM Committee F24 practices.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
amusement rides and devices; design; manufacture;; ICS Number Code 97.200.99 (Other equipment for entertainment)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Feb. 1, 2017