ASTM-F1318 Standard Test Method for Determination of Productivity Using Electrostatic Copy Machines with Various Configurations (Withdrawn 2017)

ASTM-F1318 - 1990 R09 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Determination of Productivity Using Electrostatic Copy Machines with Various Configurations (Withdrawn 2017)

Scope

1.1 This test method covers the determination of productivity using electrostatic copy machines with various combinations of accessories and in different operating modes.

1.2 The results from this test method will enable copy machine users to compare the productivity of similarly equipped copiers to each other or the productivity of a copy machine can be compared with itself in its various configurations.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method is used to determine the copy per minute rating (productivity) of electrostatic copiers under standard conditions. It measures the time required to copy a specific standard load on a copy machine. This productivity value is to be compared to the repeat copy rate for the same machine to see if there is a change in the efficiency of the machine when various accessories or combinations of accessories are added to or used on the machine, or when the work load changes. It can also be used to compare the efficiencies of different but similarly equipped copy machines. It is suitable for productivity evaluation by the user, and in research and development.

Keywords

copier; copier efficiency; copier productivity; copier throughput; electrostatic copiers; xerography; Copy per minute (productivity); Electrostatic copier; Productivity; ICS Number Code 37.100.10 (Reproduction equipment)

To find similar documents by ASTM Volume:

15.09 (Paper; Business Imaging Products)

15.11 (Consumer Products; Light Sport Aircraft; Unmanned Aircraft Systems; Normal and Utility Category Airplane Electrical Wiring Systems; Unmanned Maritime Vehicle Systems (UMVS))

To find similar documents by classification:

37.100.10 (Reproduction equipment Including printing, copying and duplicating machines, bookbinding equipment, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-F1318-90(2009)

Revision Level

1990 R09 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

Feb. 1, 2009

Document Type

Test Method

Page Count

8 pages

Committee Number

F05.04