ASTM-F1667 › Historical Revision Information
Standard Specification for Driven Fasteners: Nails, Spikes, and Staples
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers nails, spikes, staples, and other driven fasteners, as listed in Fastener ductility information is presented in and dimensional information in Table 1.
Note—Fastener ductility information is presented in Table 2 and dimensional information in Tables 3-63.
1.2 Fasteners described in this specification are driven by hand tool, power tool, or mechanical device in single or multiple strikes and may be positioned for striking by hand, tool, or machine.
1.3 The values stated in inch-pound units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
diameter; driven fasteners; head; length; nails; point; spikes; staples; ICS Number Code 21.060.01 (Fasteners in general)
To find similar documents by ASTM Volume:
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
21.060.01 (Fasteners in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1667-01
Revision Level
2001 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
June 10, 2001
Document Type
Specification
Page Count
40 pages
Committee Number
F16.05