ASTM-F1810 Standard Test Method for Counting Preferentially Etched or Decorated Surface Defects in Silicon Wafers (Withdrawn 2003)

ASTM-F1810 - 1997 R02 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Counting Preferentially Etched or Decorated Surface Defects in Silicon Wafers (Withdrawn 2003)

Scope

This standard was transferred to SEMI (www.semi.org) May 2003

1.1 This test method describes the technique to count the density of surface defects in silicon wafers by microscopic analysis.

Note 1—Practical use of a defect counting method requires an assumption be made that defects are randomly distributed on the surface. If this assumption is not met, the accuracy and precision of this test method will be diminished.

1.2 Application of this test method is limited to specimens that have discrete, identifiable artifacts on the surface of the silicon sample. Typical samples have been preferentially etched according to Guide F 1809 or epitaxially deposited, forming defects in a silicon layer structure.

1.3 Wafer thickness and diameter for this test method is limited only by the range of microscope stage motions available.

1.4 This test method is applicable to silicon wafers with defect density between 0.01 and 10 000 defects per cm2.

Note 2—The commercially significant defect density range is between 0.01 to 10 defects per cm2, but this test method extends to higher defect levels due and improved statistical sampling obtained with higher counts.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

defect density; dislocation; grain boundary; microscopic; polycrystalline imperfection; preferential etch; silicon; slip; ICS Number Code 29.045 (Semiconducting materials)

To find similar documents by ASTM Volume:

10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)

To find similar documents by classification:

29.045 (Semiconducting materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-F1810-97(2002)

Revision Level

1997 R02 EDITION

Status

Superseded

Modification Type

Withdrawn

Publication Date

Dec. 10, 2002

Document Type

Test Method

Page Count

4 pages

Committee Number

F01.06