ASTM-F1821 Historical Revision Information
Standard Consumer Safety Specification for Toddler Beds

ASTM-F1821 - 2019 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This consumer safety specification deals with the requirements for the design and performance of toddler beds. It also contains requirements for labeling and instructional material. This consumer safety specification is intended to minimize incidents to children resulting from normal use and reasonably foreseeable misuse of toddler beds. It does not address incidents resulting from alteration or unreasonable misuse. Materials shall be tested and shall conform to requirements of small parts, paint and surface coating, scissoring, shearing, and pinching, protective components, openings, labeling, corner post extensions, mattress retention, mattress support system, mattress support system attachment to end structures, guardrails, end structures, partially bounded openings, and permanency of labels and warnings.

ORDER

Scope

1.1 This consumer safety specification covers requirements for the design and performance of toddler beds. It also contains requirements for labeling and instructional material.

1.2 This consumer safety specification is intended to minimize incidents to children resulting from normal use and reasonably foreseeable misuse of toddler beds. It does not address incidents resulting from alteration or unreasonable misuse.

1.3 For the purposes of this consumer safety specification, a toddler bed is a bed that is sized to accept a full-size crib mattress and is intended for use by a child not less than 15 months of age and who weighs no more than 50 lb (27.7 kg).

1.4 No toddler bed produced after the approval date of this consumer safety specification shall indicate compliance with this specification, either by label or by other means, unless it conforms to all the requirements contained herein.

1.5 This consumer safety specification includes the following sections:

Scope

Section 1

Referenced Documents

Section 2

Terminology

Section 3

Calibration and Standardization

Section 4

General Requirements

Section 5

Performance Requirement

Section 6

Test Methods

Section 7

Marking and Labeling

Section 8

Instructional Literature

Section 9

Keywords

Section 10

1.6 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.7 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

bed; toddler;

To find similar documents by ASTM Volume:

15.11 (Consumer Products; Light Sport Aircraft; Unmanned Aircraft Systems; Normal and Utility Category Airplane Electrical Wiring Systems; Unmanned Maritime Vehicle Systems (UMVS))

To find similar documents by classification:

97.190 (Equipment for children Including child safety requirements for other household equipment Children's furniture, see 97.140 Playgrounds, see 97.200.40 Toys, see 97.200.50)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-F1821-19

Revision Level

2019 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

June 1, 2019

Document Type

Specification

Page Count

11 pages

Committee Number

F15.18