Document Center is acquired by Nimonik

Scope

1.1 This practice covers an accelerated procedure intended to screen ink jet prints for lightfastness in office environments where overhead fluorescent light and window-filtered daylight is used for illumination.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 8.

Significance and Use

Lightfastness of printed ink jet media for specified periods of time is pertinent to the end use of these materials. Since the ability of an ink jet print to withstand color changes is a function of the spectral power distribution of the light source to which it is exposed, it is important that the effect of accelerated testing be assessed under the conditions appropriate to the end use application. While ink jet prints may be handled and displayed under a variety of conditions, this practice is intended to produce the color changes that may occur in ink jet prints upon exposure to irradiation from office lighting where overhead fluorescent light and window-filtered daylight is used for illumination by simulating these conditions.

The accelerated procedure covered in this practice is intended to provide a means for the rapid evaluation of the effect of light under laboratory conditions. Test results are useful for specification acceptance between producer and user, for quality control, and for research and product development.

Color changes may not be a linear function of duration of exposure. The preferred method of determining the effect of light is to expose the prints for a number of intervals and to assess the exposure time required to obtain a specific color change.

Keywords

accelerated testing ; color change ; image stability ; ink jet ; ink jet prints ; lightfastness ; UV exposure ; window-filtered daylight; Accelerated aging/testing--copy materials; Daylight; Fluorescent lamps/lighting; Lightfastness; Overhead fluorescent lighting; Window-filtered daylight; ICS Number Code 87.080 (Inks. Printing inks)

To find similar documents by ASTM Volume:

15.09 (Paper; Business Imaging Products)

15.11 (Consumer Products; Light Sport Aircraft; Unmanned Aircraft Systems; Normal and Utility Category Airplane Electrical Wiring Systems; Unmanned Maritime Vehicle Systems (UMVS))

To find similar documents by classification:

87.080 (Inks. Printing inks Materials for graphic technology, see 37.100.20)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.