Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of both dimensions (length and width) and squareness of resilient floor tile. This test method is intended for use with square tiles ranging from a nominal 9 in. to 40 in. in dimension.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Both dimension and squareness of resilient floor tile are important considerations, because installed flooring may exhibit an objectionable appearance when either or both characteristics deviate from established tolerances. This test method provides a means of determining actual dimensions and squareness by using a single apparatus and procedure. This test method may be used as a substitute for Test Methods F 536 and F 540, which allow for similar measurements on resilient floor tile up to 12 in. (305 mm) in size.

Keywords

dial gage; resilient flooring; resilient tile; tile; ICS Number Code 97.150 (Non-textile floor coverings)

To find similar documents by ASTM Volume:

15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)

To find similar documents by classification:

97.150 (Non-textile floor coverings Textile floor coverings, see 59.080.60)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.