ASTM-F2191 › Historical Revision Information
Standard Specification for Packing Material, Graphitic or Carbon Braided Yarn
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers staple or continuous filament carbon/graphite yarn valve stem compression packing, suitable for use as end-rings on packing systems for valves. Intended services include steam, hydrocarbons, water and non-oxidizing chemicals. Where this specification is invoked as ASTM F2191, Sections 1 – 18 apply. Where this specification is invoked as ASTM/DoD F2191, Sections 1 – 18 and the Supplementary Requirements shall be applicable.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
To find similar documents by ASTM Volume:
01.07 (Ships and Marine Technology)
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F2191/F2191M-13
Revision Level
2013 EDITION
Status
Superseded
Modification Type
Revision with Designation Change
Publication Date
Jan. 15, 2014
Document Type
Specification
Page Count
9 pages
Committee Number
F25.02