ASTM-F2231 › Standard Test Method for Charpy Impact Test on Thin Specimens of Polyethylene Used in Pressurized Pipes
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes the specimen preparation and the method of measuring the impact energy of polyethylene used in pressurized pipes.
1.2 The test specimens are taken from compression molded plaques of the resin from pellets or pipe.
1.3 UnitsThe values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
polyethylene; pipes; pellets
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F2231-02R24
Revision Level
2002 R24 EDITION
Status
Current
Modification Type
New
Publication Date
Feb. 16, 2024
Document Type
Test Method
Page Count
3 pages
Committee Number
F17.40