ASTM-F2280 Standard Specification for “Twist Off” Type Tension Control Structural Bolt/Nut/Washer Assemblies, Steel, Heat Treated, 150 ksi Minimum Tensile Strength (Withdrawn 2016)

ASTM-F2280 - 2014 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


Formerly under the jurisdiction of Committee F16 on Fasteners,this specification was withdrawn in May 2016 and replaced by Specification for High Strength Structural Bolts, Steeland Alloy Steel, Heat Treated, 120 ksi (830 MPa) and 150 ksi (1040MPa) Minimum Tensile Strength, Inch and Metric Dimensions. Specification supersedes and replaces specifications; A325, A325M, A490, A490M, F1852 and F2280. The unified Specification corrects known inconsistencies in the original documents and the combination will assure that requirements of the products covered under the original standards stay aligned. For referenced ASTM standards, visit the ASTM website, www.astm.org,or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Standards volume information, refer to the standard’sDocument Summary page on ASTM website.
ORDER

Keywords

alternate design fasteners; bolts; alloy steel; fasteners; spline end; structural; tension control bolt; tension control bolt assembly; twist-off bolt; weathering steel; ICS Number Code 21.060.01 (Fasteners in general)

To find similar documents by ASTM Volume:

01.08 (Fasteners; Rolling Element Bearings)

To find similar documents by classification:

21.060.01 (Fasteners in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-F2280-14

Revision Level

2014 EDITION

Status

Superseded

Modification Type

Replaced

Publication Date

Oct. 1, 2014

Document Type

Specification

Page Count

7 pages

Committee Number

F16.02