ASTM-F2417 Standard Specification for Fire Safety for Candles

ASTM-F2417 - 2023 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Specification for Fire Safety for Candles
ORDER

Price:

$63.00        


Want this as a site license?

Scope

1.1 This specification is intended to prescribe minimum safety requirements for candles and candle ensembles to provide a reasonable degree of safety for normal use with candles, thereby improving personal safety and reducing fires, deaths, and injuries.

1.2 This specification is not intended to replace other important safety practices that should be in place, such as adult supervision, close monitoring, fire detection, alarm or suppression systems, and use of candles away from combustible materials.

1.3 This specification is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

1.4 This standard is used to predict or provide a quantitative measure of the fire hazard from a specified set of fire conditions involving specific materials, products, or assemblies. This assessment does not necessarily predict the hazard of actual fires which involve conditions other than those assumed in the analysis.

1.5 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

1.6 This specification states values in inch-pound units which are to be regarded as the standard. The values given in parenthesis are for information only.

1.7 This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

candles; end of useful life; fire safety testing; flame height; gel; secondary ignition; stability; tealight; tealight cup;

To find similar documents by ASTM Volume:

15.11 (Consumer Products; Light Sport Aircraft; Unmanned Aircraft Systems; Normal and Utility Category Airplane Electrical Wiring Systems; Unmanned Maritime Vehicle Systems (UMVS))

To find similar documents by classification:

13.220.20 (Fire protection Including equipment)

97.180 (Miscellaneous domestic and commercial equipment Including scissors, aquarium equipment, articles for domestic animals, battery chargers, mops, insect electrocutors, lighters, matches, paper clips, pens, pencils, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

ASTM-D127
Standard Test Method for Drop Melting Point of Petroleum Wax, Including Petrolatum

ASTM-F963
Standard Consumer Safety Specification for Toy Safety

ASTM-D2834
Standard Test Method for Nonvolatile Matter (Total Solids) in Water-Emulsion Floor Polishes, Solvent-Based Floor Polishes, and Polymer-Emulsion Floor Polishes

Document Number

ASTM-F2417-23

Revision Level

2023 EDITION

Status

Current

Modification Type

Revision

Publication Date

Aug. 23, 2023

Document Type

Specification

Page Count

8 pages

Committee Number

F15.45