ASTM-F2465 Standard Guide for Oil Spill Dispersant Application Equipment: Single-point Spray Systems

ASTM-F2465 - 2005 R16 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This guide covers performance criteria, requirements, material characteristics, and essential features for oil spill dispersant application systems. This guide also covers vessel-based spray systems employing single-point spray nozzles. Oil spill dispersant spray equipment shall conform to the minimum performance requirements such as target dosage, dispersant flow or injection rate determination, droplet size distribution, and maximum delivery variation over spray switch. Materials used in the spray systems shall be corrosion-resistant to salt water and shall be able to be used or stored at extreme temperatures. Performance data shall be provided to user, including information such as dilute versus neat application, dosage chart, accuracy of data, nozzles and pumps, and operational manual.

ORDER

Price:

$41.00        

Scope

1.1 This guide covers performance criteria, requirements, material characteristics, and essential features for oil spill dispersant application systems. This guide is not intended to be restrictive to a specific configuration.

1.2 This guide covers vessel-based spray systems employing single-point spray nozzles, including designs that have been based on or evolved from “fire-monitor” systems, and is not fully applicable to other systems such as spray boom/nozzle or aircraft systems.

1.3 This guide is one of five related to dispersant application systems. The other four guides cover the design of boom and nozzle systems, spray system calibration, spray deposition measurements, and use of the systems. Familiarity with all five guides (listed in 2.1) is recommended.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

dispersant application; dispersants; dispersant spray equipment; fire monitor; oil spill chemicals; oil spill dispersants; oil spill treating agents; single-point spray nozzles;; ICS Number Code 13.020.40 (Pollution, pollution control and conservation)

To find similar documents by ASTM Volume:

11.05 (Pesticides and Alternative Control Agents; Environmental Assessment; Hazardous Substances and Oil Spill Response)

To find similar documents by classification:

13.020.40 (Pollution, pollution control and conservation Including ecotoxicology)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-F2465/F2465M-05(2016)

Revision Level

2005 R16 EDITION

Status

Current

Modification Type

Reapproval

Publication Date

March 1, 2016

Document Type

Guide

Page Count

4 pages

Committee Number

F20.13