Document Center is acquired by Nimonik

Scope

1.1 This specification establishes requirements and test methods for dimensions and tolerances of central-vacuum hose inlet valve sockets.

1.2 All notes and footnotes shall be considered as non-mandatory requirements of the specification.

1.3 This specification does not apply to inlet valve back-up (or mounting) plates.

1.4 This standard is applicable to universal valves marked with ASTM Standard # F xxxx, and does not limit proprietary valve designs.

1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

central vacuum hose inlet valve; hose cuffs

To find similar documents by ASTM Volume:

15.08 (Sensory Evaluation; Vacuum Cleaners; Security Systems and Equipment; Detention and Correctional Facilities; Homeland Security Applications)

15.11 (Consumer Products; Light Sport Aircraft; Unmanned Aircraft Systems; Normal and Utility Category Airplane Electrical Wiring Systems; Unmanned Maritime Vehicle Systems (UMVS))

To find similar documents by classification:

97.080 (Cleaning appliances Including vacuum cleaners, floor-cleaning machines, floor polishers, steam cleaners, pressure cleaners, hand operated cleaners, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.