ASTM-F373 › Standard Test Method for Embossed Depth of Resilient Floor Coverings
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 Two important characteristics involved in the manufacture of resilient flooring relate to the smoothness of the wear surface and the hardness of the layers under the wear surface. The surfaces may vary from completely textured areas to portions that are flat but separated by textured areas. This test method covers flooring with these interrupted wear surfaces which are not supported by soft, cushioned layers.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
embossing; flooring; micrometer; resilient; texture; ICS Number Code 97.150 (Non-textile floor coverings)
To find similar documents by ASTM Volume:
15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)
To find similar documents by classification:
97.150 (Non-textile floor coverings Textile floor coverings, see 59.080.60)
To find similar documents by Federal Supply Class Code:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
BS-EN-ISO/IEC-7811-1Part 1: Embossing, Implementation of En ISO/IEC-7811-1 : 1996, Identification Cards, Recor
Document Number
ASTM-F0373-13R22
Revision Level
2013 R22 EDITION
Status
Current
Modification Type
Reapproval with Ed Change
Publication Date
June 13, 2022
Document Type
Test Method
Page Count
2 pages
Committee Number
F06.20