ASTM-F524 Test Methods for Measuring Beam Divergence of Pulsed Lasers by the Apertured-Detector Technique (Withdrawn 2001)

ASTM-F524 - 1977T R87(E1) EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Test Methods for Measuring Beam Divergence of Pulsed Lasers by the Apertured-Detector Technique (Withdrawn 2001)

Scope

1.1 These test methods cover the determination of the percentage of total beam energy contained in a given far-field divergence angle, without requiring the use of calibrated energy detectors. The methods make use of an apertured-detector technique.

1.2 These test methods apply to pulsed lasers in which the output polarization characteristics do not vary between successive pulses.

1.3 A single-detector method is used when the variation in energy from shot to shot of the laser under test is less than or equal to a value agreed upon by the parties to the test.

1.4 A double-detector method is used when the variation in energy from shot to shot of the laser under test exceeds a value agreed upon by the parties to the test.

1.5 The reported precision applies to lasers with cylindrically symmetric beam energy-density distributions. Deviation of the beam from cylindrical symmetry may decrease the precision of the test methods.

1.6 The appropriate test method may be applied for a given laser at a number of divergence angles and a relative beam-energy profile derived.

1.7 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For hazard statement, see Section 9.

Keywords

Aperture-detector technique; Double detector method; Single detector method; beam divergence of pulsed lasers,; Beam divergence; pulsed lasers, by apertured-detector technique,; Divergence; pulsed laser beams, by apertured-detector technique,; Lasers and laser applications; beam divergence (of pulsed lasers), by aperture-detector technique,; Threshold detectors; pulsed lasers, for measuring beam divergence; ICS Number Code 31.260 (Optoelectronics. Laser equipment)

To find similar documents by ASTM Volume:

10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)

To find similar documents by classification:

31.260 (Optoelectronics. Laser equipment Including photoelectric tubes and cells)

This document comes with our free Notification Service, good for the life of the document.

This document is available in Paper format.

Document Number

ASTM-F524-77T(1987)e1

Revision Level

1977T R87(E1) EDITION

Status

Superseded

Modification Type

Withdrawn

Publication Date

June 24, 1977

Document Type

Test Method

Page Count

5 pages

Committee Number

F01.02