ASTM-F627 › Standard Practice for Testing Flake of Single-Strike Film Typewriter Ribbons (Withdrawn 2015)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers two tests comparing the amount of flake of film typewriter ribbons.
1.2 A short test is recommended for partially used ribbons where flake is suspected.
1.3 A long test is recommended for use with unused ribbons that can be tested in their entirety.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This practice may be used for service evaluation, development, research, and specification acceptance.
The tests will produce significant results only if the control is the same product as the ribbon being tested.
This practice does not establish a standard or impose limits, but provides a means of assigning causes and comparing results.
Keywords
film; flake; ribbon; typewriter; Appearance of materials; Film ribbons/cartridges; Flaking; Inked ribbons; One-time film typewriter ribbons; Typewriter materials/applications
To find similar documents by ASTM Volume:
15.09 (Paper; Business Imaging Products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F627-99(2008)
Revision Level
1999 R08 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
June 1, 2008
Document Type
Practice
Page Count
3 pages
Committee Number
F05.02