ASTM-F67 › Historical Revision Information
Standard Specification for Unalloyed Titanium, for Surgical Implant Applications (UNS R50250, UNS R50400, UNS R50550, UNS R50700)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the chemical, mechanical, and metallurgical requirements for four grades of unalloyed titanium strips, sheets, plates, bars, billets, forgings, and wires used for the manufacture of surgical implants. The four grades identified here are defined as follows: Grade 1—UNS R50250; Grade 2—UNS R50400; Grade 3—UNS R50550; and Grade 4—UNS R50700. Mill products may be supplied with a descaled or pickled, abrasive blasted, chemically milled, ground, machined, peeled, or polished finish, or as specified by the purchaser. Materials shall be furnished in the hotworked, cold-worked, forged, annealed, or stress-relieved condition. Mechanical properties to which the titanium materials shall conform are ultimate tensile strength, yield strength, elongation, and reduction of area.
Scope
1.1 This specification covers the chemical, mechanical, and metallurgical requirements for four grades of unalloyed titanium strip, sheet, plate, bar, billet, forging, and wire used for the manufacture of surgical implants.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
metals (for surgical implants); orthopaedic medical devices; titanium alloys; titanium/titanium alloy; titanium/titanium alloys (for surgical implants);; ICS Number Code 11.040.40 (Implants for surgery, prothetics and orthotics)
To find similar documents by ASTM Volume:
13.01 (Medical and Surgical Materials and Devices)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F67-13(2017)
Revision Level
2013 R17 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 1, 2017
Document Type
Specification
Page Count
6 pages
Committee Number
F04.12