ASTM-F766 › Standard Test Method for Melting Point of Waxes (Withdrawn 2016)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the initial and final melting points and recovery point of waxes using a hot stage and microscope.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 8 for a specific precautionary statement.
Significance and Use
This test method determines the initial melting point and melting range of waxes. The data obtained are important in the application of waxes in one-time carbon inks.
Keywords
melting; melting point; waxes; Microscopic examination; Petroleum wax; Temperature tests; Heating tests--chemicals/materials; Melting point; ICS Number Code 71.100.99 (Other products of the chemical industry)
To find similar documents by ASTM Volume:
15.09 (Paper; Business Imaging Products)
To find similar documents by classification:
71.100.99 (Other products of the chemical industry)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F766/F766M-82(2010)e1
Revision Level
1982 R10(E1) EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Dec. 1, 2010
Document Type
Test Method
Page Count
2 pages
Committee Number
F05.02