ASTM-F837M › Historical Revision Information
Standard Specification for Stainless Steel Socket Head Cap Screws [Metric]
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers the chemical and mechanical requirements for stainless steel metric socket head cap screws (SHCS) with nominal thread M1.6 through M36 and intended for use in applications requiring general corrosion resistance.
1.2 Two groups of stainless steel alloys are covered, austenitic Grade A1 and martensitic Grade C1.
1.3 Three property classes are covered: austenitic A1-50 in an annealed condition at 500 MPa minimum, A1-70 in a cold worked condition at 700 MPa minimum, and martensitic C1-110 in a heat treated condition at 1100 MPa minimum.
1.4 This hazard statement pertains only to Section 13, Test Methods: This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
head cap screws; stainless steel-screws; steel bolting materials-screws; socket head cap screws (SHCS)-stainless steel, nominal thread; ICS Number Code 21.060.10 (Bolts, screws, studs)
To find similar documents by ASTM Volume:
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
21.060.10 (Bolts, screws, studs)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F837M-00
Revision Level
2000 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 10, 2000
Document Type
Specification
Page Count
7 pages
Committee Number
F16.04