ASTM-F905 › Standard Practice for Qualification of Polyethylene Saddle-Fused Joints
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes test criteria suitable for qualification of polyethylene saddle fusion joints. These tests may be conducted by suppliers or users to qualify saddle fusion joints in accordance with the requirements found in the Department of Transportation (DOT) Code of Federal Regulations (CFR) Title 49, Part 192.283. If desired, these tests may also be conducted by users to qualify personnel making saddle fusion joints per DOT CFR 49, Part 192.285.
1.2 The impact resistance test described is a nonstandard test. This is not the only test that may be used to qualify saddle fusion joints per DOT regulations.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Fusion joints; Joints;empipe applications; Polyethylene (PE) fittings; Polyethylene (PE) pipe; Saddle fusion joints; qualification of polyethylene saddle fusion joints, spec.,; Qualifications; polyethylene saddle fusion joints; ICS Number Code 83.140.99 (Other rubber and plastic products)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
83.140.99 (Other rubber and plastics products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F0905-04R22
Revision Level
2004 R22 EDITION
Status
Current
Modification Type
Revision
Publication Date
Nov. 7, 2022
Document Type
Practice
Page Count
3 pages
Committee Number
F17.60