ASTM-F951 Standard Test Method for Determination of Radial Interstitial Oxygen Variation in Silicon Wafers (Withdrawn 2003)

ASTM-F951 - 2002 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Determination of Radial Interstitial Oxygen Variation in Silicon Wafers (Withdrawn 2003)

Scope

This standard was transferred to SEMI (www.semi.org) May 2003

1.1 This test method covers test site selection and data reduction procedures for radial variation of the interstitial oxygen concentration in silicon slices typically used in the manufacture of microelectronic semiconductor devices.

1.2 This test method is intended as both a referee and production test through selection of an appropriate test position plan.

1.3 The interstitial oxygen content may be measured in accordance with Test Methods F 1188 or F 1619, DIN 50438/1, JEIDA 61, or any other procedure agreed upon by the parties to the test.

Note 1—Test Method F 1366 is not based on infrared absorption measurement and it measures total oxygen content, not interstitial oxygen content. It is also a destructive technique. However, it can be used to determine the radial variation of the oxygen content if suitable modifications of the test procedure are made.

1.4 Acceptable thickness and surface finish for the test specimens are specified in the applicable test methods. This test method is suitable for use on chemically etched, single-side polished and double-side polished silicon wafers or slices with no surface defects that could adversely change infrared radiation transmission through the test specimen (subsequently called slice), provided that appropriate test methods for oxygen content are selected.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

infrared transmission; interstitial oxygen; oxygen; radial variation; silicon; uniformity; variation; ICS Number Code 29.045 (Semiconducting materials)

To find similar documents by ASTM Volume:

10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)

To find similar documents by classification:

29.045 (Semiconducting materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

MIL-STD-105
Sampling Procedures and Tables for Inspection by Attributes (See Cancellation Notice 3 for Additional Information) Use ASQ-Z1.4 and MIL-STD-1916

MIL-STD-883
Microcircuits

JESD-22-A112
Test Method a112: Moisture-Induced Stress Sensitivity for Plastic Surface Mount Device

Document Number

ASTM-F951-02

Revision Level

2002 EDITION

Status

Superseded

Modification Type

Withdrawn

Publication Date

Jan. 10, 2002

Document Type

Test Method

Page Count

5 pages

Committee Number

F01.06