ASTM-F995 Standard Practice for Estimating Toner Usage in Copiers Utilizing Dry Two-Component Developer (Withdrawn 2017)

ASTM-F995 - 2009 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Estimating Toner Usage in Copiers Utilizing Dry Two-Component Developer (Withdrawn 2017)

Scope

1.1 This practice describes a procedure for estimating the number of copies that can be produced for a given unit of toner in a copier using dry two-component developer.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 9 for specific precautionary statements.

Significance and Use

This practice may be used to evaluate the performance of different toners in a common machine. It can also be used to evaluate the economics of toner usage when making machine-to-machine comparisons.

The practice provides only a point estimate that is subject to a significant number of variables that are not easily measured. As with all dry developers, two-component developer systems are not 100 % efficient. Some toner is lost to the surroundings (inside or outside the copier). This loss is also dependent on copier adjustments and may be significant enough to affect the total number of copies capable of being produced by a specific amount of toner. Anyone making a decision based on the results of this practice should carefully consider the accuracy of the results and other pertinent data.

Actual use of the copier in normal operating conditions will most likely result in toner usage values different from those generated in this practice.

Keywords

copiers; test target; toner usage; two-component toner; Developers; Electrostatic copier; Point count; Toner usage; Two-component developer materials; ICS Number Code 37.100.10 (Reproduction equipment)

To find similar documents by ASTM Volume:

15.09 (Paper; Business Imaging Products)

15.11 (Consumer Products; Light Sport Aircraft; Unmanned Aircraft Systems; Normal and Utility Category Airplane Electrical Wiring Systems; Unmanned Maritime Vehicle Systems (UMVS))

To find similar documents by classification:

37.100.10 (Reproduction equipment Including printing, copying and duplicating machines, bookbinding equipment, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-F995-09

Revision Level

2009 EDITION

Status

Superseded

Modification Type

Withdrawn

Publication Date

Oct. 1, 2009

Document Type

Practice

Page Count

5 pages

Committee Number

F05.04