IEC-60153-4 › Hollow metallic waveguides - Part 4: Relevant specifications for circular waveguides
Document Center Inc. is an authorized dealer of IEC standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
IEC 60153-4:2022 specifies straight hollow metallic tubing of circular cross section for use as waveguides in electronic equipment. The aim of this document is to specify the hollow metallic waveguides:
a) the details necessary to ensure compatibility and, as far as essential, interchangeability;
b) test methods;
c) uniform requirements for the electrical and mechanical properties
This document is intended to be read in conjunction with IEC 60153-1, which gives general requirements and test methods. This fourth edition cancels and replaces the third edition published in 2017. edition:
a. change of the designation scheme for small circular waveguides (e.g. C 25.5k instead of C 25500);
b. revision of Table 1:
- correction of two waveguide designations (now C 1.2k, C 12k);
- correction of three waveguide diameters (C 140, C 1.4k, C 14k);
- tightening of inner diameter tolerances for waveguides smaller than C 890;
- deletion of waveguide attenuation values for aluminium, gold, and brass;
c. deletion of Table 2 (duplication) and replacement with the table of intermediate waveguide sizes originally envisaged here;
d. addition of an equation for calculating the attenuation of waveguides made of any material.
To find similar documents by classification:
33.120.10 (Coaxial cables. Waveguides)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
IEC 60153-4 Ed. 4.0 b:2022
Revision Level
EDITION 4.0
Status
Current
Publication Date
June 1, 2022
Committee Number
46F