IEC-60851-5 › Winding wires - Test methods - Part 5: Electrical properties
Document Center Inc. is an authorized dealer of IEC standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Included in this current edition are the following subparts:
EDITION 4.2 - Sept. 1, 2019
FOR ED. 4.0 AMENDMENT 2 SEE - Sept. 1, 2019
FOR ED. 4.0 AMENDMENT 2 SEE - Sept. 1, 2019
IEC 60851-5:2008+A1:2011+A2:2019 specifies the following tests:
- Test 5: Electrical resistance;
- Test 13: Breakdown voltage;
- Test 14: Continuity of insulation;
- Test 19: Dielectric dissipation factor.
Significant revisions to the previous edition include the following points:
- In Subclause 5.3, the addition of the use of carbon brush electrodes for the counting discontinuities during the high voltage continuity test, as an alternative to the V-groove pulley electrode; and
- Clarifications in the breakdown voltage test for round wires larger than 2,500 mm and for fibrous covered wires.
This consolidated version consists of the fourth edition (2008), its amendment 1 (2011) and its amendment 2 (2019). Therefore, no need to order amendment in addition to this publication.
To find similar documents by classification:
29.060.10 (Wires Including electric rods, busbars, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
IPC-A-610Acceptability of Electronic Assemblies (Hardcopy format)
IPC/EIA-J-STD-001
Requirements for Soldered Electrical and Electronic Assemblies
ASTM-A480
Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip
Document Number
IEC 60851-5 Ed. 4.2 b:2019
Revision Level
EDITION 4.2
Status
Current
Publication Date
Sept. 1, 2019
Committee Number
55