IEC-60947-7-5 › Low-voltage switchgear and controlgear - Part 7-5: Ancillary equipment - Terminal blocks for aluminium conductors
IEC-60947-7-5
-
EDITION 1.0
-
CURRENT
Document Center Inc. is an authorized dealer of IEC standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
IEC TS 60947-7-5:2021 specifies requirements for terminal blocks with screw-type or screwless-type clamping units primarily intended for industrial or similar use and to be fixed to a support to provide electrical and mechanical connection. This document can be used for terminal blocks for connection between aluminium conductors or aluminium to copper conductors. It applies to terminal blocks intended to connect round conductors, with or without special preparation, having a cross-section between 2,5 mm2 and 300 mm2 (AWG 12 to 600 kcmil), intended to be used in circuits of a rated voltage not exceeding 1 000 V AC (up to 1 000 Hz) or 1 500 V DC.
To find similar documents by classification:
29.130.20 (Low voltage switchgear and controlgear Including switchgear and controlgear assemblies)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
IEC/TS 60947-7-5 Ed. 1.0 b:2021
Revision Level
EDITION 1.0
Status
Current
Publication Date
Nov. 1, 2021
Committee Number
121A