IEC-61290-10-1 › Optical amplifiers - Test methods - Part 10-1: Multichannel parameters - Pulse method using an optical switch and optical spectrum analyzer
Document Center Inc. is an authorized dealer of IEC standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
IEC 61290-10-1:2009 applies to optical fibre amplifiers (OFAs) using active fibres, containing rare-earth dopants, currently commercially available. The uniform requirements for accurate and reliable measurements of the signal-spontaneous noise figure as defined in 3.1.18 of IEC 61291-1 are established. The test method independently detects amplified signal power and amplified spontaneous emission (ASE) power by launching optical pulses into the OFA under test and synchronously detecting 'on' and 'off' levels of the output pulses by using an optical sampling switch and an optical spectrum analyzer (OSA). This edition is a technical revision with updated references and cautions on proper use of the procedure.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
IEC 61290-10-1 Ed. 2.0 b:2009
Revision Level
EDITION 2.0
Status
Current
Publication Date
March 1, 2009
Committee Number
86C