ISO-10447 › Resistance welding - Testing of welds - Peel and chisel testing of resistance spot and projection welds
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 10447:2015 specifies the procedures and recommended tooling to be used for peel and chisel testing of resistance spot and projection welds. ISO 10447:2015 applies to welds made in two or more sheets in the thickness range of 0,5 mm to 3,0 mm.
The aim of these tests is to determine
- weld size and failure type when welds are destructively tested, and
- verification of welds by non-destructive chisel tests.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:ISO-273
Fasteners - Clearance holes for bolts and screws
Structural Welding Code - Steel (Now AWS-D1.1/D1.1M)
Aluminum Alloy, Plate, 6.2Zn - 2.3Cu - 2.2Mg - 0.12Zr (7050-T7451), Solution Heat Treated, Stress Relieved, and Overaged
Feb. 1, 2015