ISO-10467 › Historical Revision Information
Plastics piping systems for pressure and non-pressure drainage and sewerage - Glass-reinforced thermosetting plastics (GRP) systems based on unsaturated polyester (UP) resin

ISO-10467 - REPLACED BY ISO-23856 - SUPERSEDED -- See the following: ISO-10467-AM1 ISO-23856
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 10467:2004 specifies the properties of piping system components made from glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) for drainage or sewerage with or without pressure, as well as the properties of the system itself.

It is applicable to GRP-UP piping systems, with flexible or rigid joints with or without end thrust load-bearing capability, primarily intended for use in buried installations.

It is applicable to pipes, fittings and their joints of nominal sizes from DN 50 to DN 4000 which are intended to be used for the conveyance of surface water or sewage at temperatures up to 50 °C, with or without pressure. In a pipework system, pipes and fittings of different nominal pressure and stiffness ratings may be used together.

ORDER

To find similar documents by classification:

23.040.20 (Plastics pipes)

83.140.30 (Plastics pipes and fittings for non fluid use Plastics pipes, fittings and valves for general use, see 23.040.20, 23.040.45 and 23.060)

91.140.80 (Drainage systems Sewage water disposal and treatment, see 13.060.30 Drainage systems for rainwater, see 91.060.20 External sewage systems, see 93.030)

93.030 (External sewage systems Sewage water disposal and treatment, see 13.060.30 Internal drainage systems, see 91.140.80)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO-10467

Revision Level

REPLACED BY ISO-23856

Status

Superseded

Publication Date

June 1, 2021

Committee Number

ISO/TC 138/SC 6