ISO-10816-4 › Historical Revision Information
Mechanical vibration - Evaluation of machine vibration by measurements on non-rotating parts - Part 4: Gas turbine driven sets excluding aircraft derivatives
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 10816-4:2009 establishes specific provisions for evaluating the severity of in-situ, broad-band vibration measured radial (i.e. transverse) to the shaft axis on all main bearing housings or pedestals and in the axial direction on thrust bearings. These are in terms of:
- vibration under normal steady-state operating conditions;
- vibration during other (non-steady-state) conditions when transient changes are taking place, including run up or run down, initial loading and load changes;
- changes in vibration which can occur during normal steady-state operation.
ISO 10816-4:2009 is applicable to heavy-duty gas turbine sets used in electrical and mechanical drive applications, with fluid-film bearings, outputs greater than 3 MW and an operating speed range under load between 3 000 r/min and 30 000 r/min.
To find similar documents by classification:
27.040 (Gas and steam turbines. Steam engines Hydraulic turbines, see 27.140)
Document Number
ISO 10816-4:1998
Revision Level
1ST EDITION
Status
Superseded
Publication Date
July 1, 1998
Committee Number
ISO/TC 108/SC 2