ISO-11542-1 › Plastics -- Ultra-high-molecular-weight polyethylene (PE-UHMW) moulding and extrusion materials -- Part 1: Designation system and basis for specifications
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 11542 establishes a system of designation for PE-UHMW thermoplastic materials which may be used as the basis for specifications.
For the purposes of this part of ISO 11542, PE-UHMW materials are polyethylene materials having a melt mass-flow rate (MFR), measured at 190 °C and 21,6 kg load, of less than 0,1 g/10 min.
The types of PE-UHMW are differentiated from each other by a classification system based on appropriate levels of the designatory properties
- viscosity number
- elongational stress
- Charpy notched impact strength
This part of ISO 11542 is applicable to all PE-UHMW homopolymers and to ultra-high-molecular-weight copolymers of ethylene having a content of other 1-olefinic monomers of less than 50 % by mass and a content of non-olefinic monomers with functional groups up to a maximum of 3 % by mass.
It applies to materials ready for normal use in the form of powder, granules or pellets and to materials unmodified or modified by colorants, additives, fillers, etc.
It is not intended to imply that materials having the same designation give necessarily the same performance. This part of ISO 11542 does not provide engineering data, performance data or data on processing conditions which may be required to specify a material for a particular application and/or method of processing.
If such additional properties are required, they shall be determined in accordance with the test methods specified in part 2 of this International Standard, if suitable.
In order to specify a thermoplastic material for a particular application or to ensure reproducible processing, additional requirements may be given in data block 5 (see 3.1).
To find similar documents by classification:
83.080.20 (Thermoplastic materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-E18Standard Test Methods for Rockwell Hardness of Metallic Materials
ASTM-A479
Standard Specification for Stainless Steel Bars and Shapes for Use in Boilers and Other Pressure Vessels
ASTM-A484
Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings
Document Number
ISO 11542-1:2001
Revision Level
2ND EDITION
Status
Superseded
Publication Date
Feb. 15, 2001
Committee Number
ISO TC 61/SC 9/WG 6