ISO-12129-2 › Plain bearings - Tolerances - Part 2: Tolerances on form and position and surface roughness for shafts and thrust collars
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This document specifies tolerances on form and position as well as the surface roughness of shafts, flanges and thrust collars as used in plain bearing units. It is applicable to journal or thrust plain bearing units or to a combination of both, installed either horizontally or vertically.
This document is not applicable to crankshaft bearing units in combustion engines.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
April 1, 2019
ISO/TC 123/SC 3