ISO-12240-1 › Spherical plain bearings - Part 1: Radial spherical plain bearings
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 12240 specifies dimension series, tolerances and radial internal clearances for radial spherical plain bearings.
The dimensions and tolerances specified in this part of ISO 12240 have been selected to permit the design of radial spherical plain bearings using a wide choice of sliding material combinations.
The specified tolerance values apply to finished, radial spherical plain bearings before any coating, plating, ring splitting or ring fracturing.
In the case of surface treated radial spherical plain bearings, there may be slight deviations from the specified tolerance values.
Radial spherical plain bearings need not conform to the designs illustrated but compliance is required as regards the dimensions, tolerances and radial internal clearances specified.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-B249Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings
ASTM-E18
Standard Test Methods for Rockwell Hardness of Metallic Materials
ASTM-D217
Standard Test Methods for Cone Penetration of Lubricating Grease
Document Number
ISO 12240-1:1998
Revision Level
1ST EDITION
Status
Current
Publication Date
Aug. 15, 1998
Committee Number
ISO TC 4/SC 7