ISO-128-50 › Technical drawings -- General principles of presentation -- Part 50: Basic conventions for representing areas on cuts and sections
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 128 specifies general principles for representing areas on cuts and sections on technical drawings (mechanical, electrical, architectural, civil-engineering etc.) following the orthographic projection methods specified in ISO 5456-2.
Attention has also been given to the requirements of reproduction, including microcopying in accordance with ISO 6428.
To find similar documents by classification:
01.100.01 (Technical drawings in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A240Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
ASTM-A269
Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing for General Service
ASTM-A312
Standard Specification for Seamless, Welded, and Heavily Cold Worked Austenitic Stainless Steel Pipes
Document Number
ISO 128-50:2001
Revision Level
1ST EDITION
Status
Superseded
Publication Date
April 15, 2001
Committee Number
ISO TC 10/SC 1