ISO-14373 Historical Revision Information
Resistance welding - Procedure for spot welding of uncoated and coated low carbon steels

ISO-14373 - 1ST EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 14373:2006 specifies requirements for resistance spot welding in the fabrication of assemblies of uncoated and metallic coated low carbon steel, comprising two or three sheets of metal, where the maximum single sheet thickness of components to be welded is within the range 0,4 mm to 3 mm, for the following materials:

  • uncoated steels;
  • hot dip zinc or iron-zinc alloy (galvannealed) coated steel;
  • electrolytic zinc, zinc-iron, or zinc-nickel coated steel;
  • aluminium coated steel;
  • zinc-aluminium coated steel.

ISO 14373:2006 is applicable to the welding of sheets of the same or dissimilar thickness, where the thickness ratio is less than or equal to 3:1. It applies to the welding of three thicknesses, where the total thickness is less than or equal to 9 mm.

Welding with the following types of equipment is within the scope of ISO 14373:2006:

  • pedestal welding equipment;
  • gun welders;
  • automatic welding equipment where the components are fed by robots or automatic feeding equipment;
  • multi welders;
  • robotic welders.

The welding of organic coated or primer coated steels is not within the scope of ISO 14373:2006.

ORDER

To find similar documents by classification:

25.160.10 (Welding processes Including thermal cutting and cladding)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 14373:2006

Revision Level

1ST EDITION

Status

Superseded

Publication Date

Aug. 15, 2006

Committee Number

ISO/IIW