ISO-14922-4 › Thermal spraying -- Quality requirements of thermally sprayed structures -- Part 4: Elementary quality requirements
The following bibliographic material is provided to assist you with your purchasing decision:
This standard specifies requirements so that:
- It is independent of the type of the thermally sprayed structure.
- It defines quality requirements for thermal spraying both in workshops and on site.
- It provides guidance for describing a manufacturer's capability to produce thermally sprayed constructions to meet specified requirements.
- It may also be used as a basis for assessing the manufacturer in respect to his thermal spraying capability.
This standard is appropriate when demonstration of a manufacturer's capability to produce thermally sprayed construction, fulfilling specified quality requirements, are specified in one or more of the following:
- a contract between involved parties;
- an application standard;
- a regulatory requirement.
The requirements contained within this standard may be adopted in full or may be selectively deleted by the manufacturer if not applicable to the construction concerned. They provide a flexible framework for the control of thermal spraying in the following cases:
Case 1
To provide specific requirements for thermal spraying in contracts which require the manufacturer to have a quality system other than EN ISO 9001 or EN ISO 9002.
Case 2
To provide specific requirements for thermal spraying in contracts which require the manufacturer developing a quality system.
Case 3
To provide specific requirements for thermal spraying in application standards which uses thermal spraying as part of its requirements or in a contract between relevant parties.
To find similar documents by classification:
25.220.20 (Surface treatment Including anodization, conversion coating, thermal spraying, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 14922-4:1999
Revision Level
1ST EDITION
Status
Superseded
Publication Date
June 15, 1999
Committee Number
ISO TC 107/WG 1