ISO-15641 › Milling cutters for high speed machining - Safety requirements
The following bibliographic material is provided to assist you with your purchasing decision:
This standard deals with the principle hazards arising from use of milling cutters, e.g. milling cutters according to ISO 3855, used for high speed machining (chip removal machining at increased peripheral speeds) on metal working machine tools and prescribes safety requirements.
It specifies design methods, centrifugal force test procedures, operational limits and the provision of information that will lead to minimisation or elimination of these hazards.
The standard is applicable to milling cutters which are intended for operation at speeds in accordance with figures 1 and 2.
These figures respectively define the rotational speed limits and peripheral speed limits for specific cutter diameters.
Figure 1 - Rotational speed n vs maximum diameter of tool D
Figure 2 - Velocity at D (speed vD) vs maximum diameter of tool D
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 15641:2001
Revision Level
1ST EDITION
Status
Current
Publication Date
Sept. 1, 2001
Committee Number
ISO/TC 29