ISO-16063-21 › Methods for the calibration of vibration and shock transducers -- Part 21: Vibration calibration by comparison with a reference transducer
The following bibliographic material is provided to assist you with your purchasing decision:
Included in this current edition are the following subparts:
1ST EDITION CORRIGENDUM 1 - April 1, 2009
FOR 1ST EDITION AMENDMENT 1 SEE - Jan. 1, 2016
ISO 16063-21:2003 describes the calibration of rectilinear vibration transducers by comparison. Although it mainly describes calibration using direct comparison to a standard calibrated by primary methods, the methods described can be applied between other levels in the calibration hierarchy.
ISO 16063-21:2003 specifies procedures for performing calibrations of rectilinear vibration transducers by comparison in the frequency range from 0,4 Hz to 10 kHz. It is primarily intended for those who are required to meet ISO standardized methods for the measurement of vibration under laboratory conditions, where the uncertainty of measurement is relatively small. It can also be used under field conditions, where the uncertainty of measurement may be relatively large.
From knowledge of all significant sources of uncertainty affecting the calibration, the expanded uncertainty can be evaluated using the methods given in ISO 16063-21. It also covers the assessment of uncertainties for calibrations performed using a check standard.
To find similar documents by classification:
17.160 (Vibrations, shock and vibration measurements Including measuring instruments and installations Vibration and shock with respect to human beings, see 13.160 Balancing and balancing machines, see 21.120.40 Vibration protection of buildings, see 91.120.25)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Aug. 15, 2003
ISO/TC 108/SC 3