ISO-16063-22 › Methods for the calibration of vibration and shock transducers - Part 22: Shock calibration by comparison to a reference transducer
The following bibliographic material is provided to assist you with your purchasing decision:
Included in this current edition are the following subparts:
FOR 1ST EDITION AMENDMENT 1 SEE - Dec. 1, 2014
ISO 16063-22:2005 specifies the instrumentation and procedures to be used for secondary shock calibration of rectilinear transducers, using a reference acceleration, velocity or force measurement for the time-dependent shock. The methods are applicable in a shock pulse duration range of 0,05 ms to 8,0 ms, and a dynamic range (peak value) of 100 m/s to 100 km/s2 (time-dependent). The methods allow the transducer shock sensitivity (i.e. the relationship between the peak values of the transducer output quantity and the acceleration) to be obtained.
These methods are not intended for the calibration of dynamic force transducers used in modal analysis.
To find similar documents by classification:
17.160 (Vibrations, shock and vibration measurements Including measuring instruments and installations Vibration and shock with respect to human beings, see 13.160 Balancing and balancing machines, see 21.120.40 Vibration protection of buildings, see 91.120.25)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
June 1, 2005
ISO/TC 108/SC 3