ISO-1641-2 › End mills and slot drills - Part 2: Dimensions and designation of milling cutters with Morse taper shanks
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 1641-2:2011 specifies the general dimensions and designation of the following milling cutters with Morse taper and having a tapped hole:
- end mills, flat-ended or ball-nosed - standard series and long series;
- slot drills - short series and standard series.
Morse taper shanks are in accordance with ISO 296 and ISO 5413.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 1641-2:2011
Revision Level
2ND EDITION
Status
Current
Publication Date
June 15, 2011
Committee Number
ISO/TC 29/SC 2