ISO-1811-2 › Copper and copper alloys - Selection and preparation of samples for chemical analysis - Part 2: Sampling of wrought products and castings
ISO-1811-2
-
1ST EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
The methods are applicable to the given materials in the form of wrought products (plate, sheet, strip, rod, bar, tube, profile, forgings, etc.) and castings (sand castings, chill castings, die castings, continuous castings, centrifugal castings).The methods are intended to determine compliance with the requirements for chemical composition. Together with ISO 1811-1 and 1811-3 this part of ISO 1811 cancels and replaces ISO Recommendation R 1811:1971, of which it constitutes a technical revision.
To find similar documents by classification:
77.120.30 (Copper and copper alloys)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 1811-2:1988
Revision Level
1ST EDITION
Status
Current
Publication Date
Oct. 1, 1988
Committee Number
ISO TC 26/SC 1